27 High Performance Live Centres C Series small housing diameter, short design Types CS, CSG Centre spindle 60° with coolant deflector and TOP-SEAL-SYSTEM Runout Type CS max. 0.003 mm Type CSG max. 0.001 mm with test report Application use where the workspace is constrained or limited for turning, high performance turning, hard turning, fine turning, cylindrical grinding Coolant deflector + TOP-SEAL-SYSTEM Coolant strikes the circular deflecting surface and its largest part is deflected away from the centre housing. The residue is wiped from the seal and flows through the drain groove. D DG LA LB LC G Type CS ID.No. 600S 032002A 600S 035003A 600S 046004A Type CSG ID.No. 601S 032002A 601S 035003A 601S 046004A Morse taper 2 3 4 D 18 22 30 DG 32 35 46 LA 19.5 23 30 LB 35.5 43.5 46 LC 60 71 81.5 G M35x1.5 M38x1.5 M48x1.5 Workpiece weight max. daN* 150 325 460 r.p.m. max.* 5500 5000 5000 Radial/axial load graph RY1/AY1 RY2/AY2 RY3/AY3 Draw-off nut (page 28) M35DIN1804 M38DIN1804 M48DIN1804 *observe the load graphs 50 40 100 200 300 5000 400 500 1000 2000 3000 4000 10000 r.p.m. 400 40 50 200 100 300 500 1000 2000 workpiece weight daN 1000 500 250 200 150 100 50 25 20 radial load daN 300 40 50 100 200 500 400 1000 2000 4000 3000 5000 10000 r.p.m. 1000 40 50 100 200 300 400 500 2000 axial load daN 3 2 1 AY 3 2 1 RY 50 40 100 200 300 5000 400 500 1000 2000 3000 4000 10000 r.p.m. 400 40 50 200 100 300 500 1000 2000 workpiece weight daN 1000 500 250 200 150 100 50 25 20 radial load daN 300 40 50 100 200 500 400 1000 2000 4000 3000 5000 10000 r.p.m. 1000 40 50 100 200 300 400 500 2000 axial load daN 3 2 1 AY 4 3 2 1 RY Radial and axial loads for a bearing life of 2000 operating hours (calculation example on page 11) Radial – Types CS/CSG Axial – Types CS/CSG
RkJQdWJsaXNoZXIy MjY2ODY=