The principle of a driving coating is to enhance the static friction between centre and workpiece. If the drive force at the workpiece exceeds the maximum static friction force of the coating the workpiece slips on the centre. Further a lubricating film between coating and workpiece can considerably reduce the static friction. Therefore a driving coating is not reliable.
The coatings driving properties are much reduced by the following:
Should these cases occur, the centres have to be put out of service immediately. Clean CARBIDOR® coatings thoroughly with a degreasing solvent, if necessary.
The centres with driving coating must not be used in other machines than those encapsuled with a safety glass. We recommend installing an overspeed trip for the workpiece. The customer is obliged to instruct the machinist/s and to warn of the risks.
Please pay attention to our attached General Terms of Trade respectively according to the special terms agreed with you which apply exclusively to our deliveries and services.
Karl Bruckner GmbH
Präzisionswerkzeugfabrik
Stand: 05/2011